statshield ? smocks grounding, testing and maintenance description desco statshield ? smocks are designed to be antistatic, low tribocharging, and create a faraday cage around the torso and arms of the wearer to protect esd susceptible items from electrostatic fields generated by clothing on the operators clothing. statshield ? smocks meet the requirement for groundable static control garment system per ansi/esd s20.20-2007s required limit of < 3.5 x 10 7 ohm rtg tested per ansi/esd stm2.1. while a person may be grounded using a wrist strap or other grounding methods, that does not mean that insulative clothing fabrics can dissipate a charge to that persons skin and then to ground. personnel clothing usually is electrically separate or isolated from the body. groundable made in the united states of america technical bulletin TB-2055 TB-2055 july 2013 page 1 of 4 ? 2013 desco industries inc. employee owned desco west - 3651 walnut avenue, chino, ca 91710 ? (909) 627-8178 desco east - one colgate way, canton, ma 02021-1407 ? (781) 821-8370 ? web site: desco.com coil cord to ground no w ristband necessary coil cord to ground wristband (not i ncluded) snaps t o c onnect t o g arment figure 2. desco statshield ? premium jacket with snaps. also available in lab coat length. figure 1. desco statshield ? premium lab coat with conductive cuffs. also available in jacket length. static control garment system, garments that are used to establish the primary ground path for a person shall provide a resistance of less than 35 megohms from the person to the groundable point of the garment.[esd tr20.20-2008 section 5.3.13 garments] statshield ? smocks are constructed of a lightweight dissipative material which made from texturized polyester and a minimum of 9% carbon nylon monofilament. the conductive nylon fibers are woven in a chain-link design throughout the material, providing continuous and consistent charge dissipation. all of the seams in statshield ? smocks are designed to maintain electrical continuity from panel to panel and from sleeve to sleeve in accordance with the esd association garment standard, esd-stm2.1. after verifying that the garment has electrical conductivity through all panels, the garment should be electrically bonded to the grounding system of the wearer so as not to act as a floating conductor. [esd tr20.20-2008 section 5.3.13 garments] the conductive fabric in smock is a conductor. if not grounded, the smock can become an isolated charged conductor. if not grounded via a wrist strap coil cord, ground the esd garment using esd footwear to esd flooring. the dissipative material becomes part of the ground path to remove static charges. statshield ? smocks are available in two lengths -- the lab coat length and the jacket length. both lengths are available in two styles - with snaps and with conductive elastic cuffs. smocks are available in eight colors* -- blue, white, teal, burgundy, black, camouflage, pink and grey. statshield ? smocks incorporate a hip-to-cuff grounding feature which allows for hands-free grounding with no cord attached to the operators wrist. this feature allows connection of a ground cord to a 4mm snap stud on the hip. a seam of carbon-suffused threads provides a secure and direct electrical connection from the snap stud on the hip to conductive elastic cuffs. statshield ? smocks ground the person when used in this manner. standard touch testing or continuous monitoring can be used to test the hip-to-cuff function. *fabric lots vary slightly in color.
statshield ? smocks are available in the following styles and sizes: lab coats with snaps lab coats with cuffs blue white teal chest sleeve blue white teal chest sleeve x small 73600 73620 73640 30"-32" 33 3/8" x small 73610 73630 73650 30"-32" 33 3/4" small 73601 73621 73641 34"-36" 34" small 73611 73631 73651 34"-36" 34" medium 73602 73622 73642 38"-40" 34 3/8" medium 73612 73632 73652 38"-40" 34 3/8" large 73603 73623 73643 42"-44" 35" large 73613 73633 73653 42"-44" 35" x large 73604 73624 73644 46"-48" 35 1/2" x large 73614 73634 73654 46"-48" 35 1/2" 2x large 73605 73625 73645 50"-52" 35 1/2" 2x large 73615 73635 73655 50"-52" 35 1/2" 3x large 73606 73626 73646 54"-56" 37 1/2" 3x large 73616 73636 73656 54"-56" 37 1/2" 4x large 73607 73627 73647 58"-60" 36 1/2" 4x large 73617 73637 73657 58"-60" 36 1/2" 5x large 73608 73628 73648 62"-64" 36" 5x large 73618 73638 73658 62"-64" 36" 6x large 73609 73629 73649 66"-68" 36" 6x large 73619 73639 73659 66"-68" 36" jackets with snaps blue white teal pink grey chest sleeve x small 73699 73820 73840 74210 73890 30"-32" 33 3/8" small 73700 73821 73841 74211 73891 34"-36" 34" medium 73710 73822 73842 74212 73892 38"-40" 34 3/8" large 73720 73823 73843 74213 73893 42"-44" 35" x large 73730 73824 73844 74214 73894 46"-48" 35 1/2" 2x large 73740 73825 73845 74215 73895 50"-52" 35 1/2" 3x large 73741 73826 73846 74216 73896 54"-56" 37 1/2" 4x large 73742 73827 73847 74217 73897 58"-60" 36 1/2" 5x large 73743 73828 73848 74218 73898 62"-64" 36" 6x large 73744 73829 73849 74219 73899 66"-68" 36" jackets with cuffs blue white teal burgundy black camo pink grey chest sleeve x small 73749 73830 73850 73900 73860 73870 74200 73775 30"-32" 33 3/4" small 73750 73831 73851 73901 73861 73871 74201 73776 34"-36" 34" medium 73755 73832 73852 73902 73862 73872 74202 73777 38"-40" 34 3/8" large 73760 73833 73853 73903 73863 73873 74203 73778 42"-44" 35" x large 73765 73834 73854 73904 73864 73874 74204 73779 46"-48" 35 1/2" 2x large 73770 73835 73855 73905 73865 73875 74205 73780 50"-52" 35 1/2" 3x large 73771 73836 73856 73906 73866 73876 74206 73781 54"-56" 37 1/2" 4x large 73772 73837 73857 73907 73867 73877 74207 73782 58"-60" 36 1/2" 5x large 73773 73838 73858 73908 73868 73878 74208 73783 62"-64" 36" 6x large 73774 73839 73859 73909 73869 73879 74209 73784 66"-68" 36" TB-2055 page 2 of 4 ? 2013 desco industries inc. employee owned desco west - 3651 walnut avenue, chino, ca 91710 ? (909) 627-8178 desco east - one colgate way, canton, ma 02021-1407 ? (781) 821-8370 ? web site: desco.com note: blue, black, camo, grey and pink jackets with cuffs contain a badge holder tab and two sleeve pen pockets.
installation follow the directions below for proper installation and grounding of the statshield ? smock. 1. put on the smock and fasten all of the snaps on the front of the smock, making sure that clothing is not exposed outside of the smock. 2. throughout use, it is essential that conductive cuff (or the wristband) be in contact with operators skin; the conductive cuff (or the wristband) should never be allowed to be pulled up and over shirt sleeve. 3. install a coil cord to the snap stud located above the left hand hip pocket. connect the other end of the coil cord to a verified ground point or continuous monitor. grounding integrity testing for daily testing or continuous monitoring of the grounding integrity of statshield ? smocks and ground cords, we recommend testing the smock while worn and the use of a standard wrist strap testers or single-wire workstation continuous monitors. panel-to-panel conductivity is essential so as not to leave portions of the smock as isolated charged conductors. panel-to-panel conductivity is easy to test using our surface resistance meter kit item # 19787 . place the two five-pound electrodes on different panels to test. unless properly grounded, the smocks can hold a charge and become a possible source for discharge to esd sensitive items. for additional information, refer to ansi/esd s20.20, esd tr20.20, esd tr53 and the garment standard, ansi/esd stm2.1. desco has several testers available for this purpose. for more information ask for specification drawings or operating instruction manuals by item number. TB-2055 page 3 of 4 ? 2013 desco industries inc. employee owned desco west - 3651 walnut avenue, chino, ca 91710 ? (909) 627-8178 desco east - one colgate way, canton, ma 02021-1407 ? (781) 821-8370 ? web site: desco.com figure 5. testing and monitoring of smock and ground cord assembly yes! yes! no! no! figure 3. proper installation of smock wearers body figure 4. grounding the smock figure 6. testers note: ansi/esd s20.20 recommends that the ground coil cord selected for grounding of personnel contain a built-in current limiting 1 megohm resistor. heat sealed patches it is possible to heat seal patches to our smocks. the patch should be small and the smock should be tested before and after application. 19276 & 19277 19784 19787
TB-2055 page 4 of 4 ? 2013 desco industries inc. employee owned desco west - 3651 walnut avenue, chino, ca 91710 ? (909) 627-8178 desco east - one colgate way, canton, ma 02021-1407 ? (781) 821-8370 ? web site: desco.com limited warranty desco expressly warrants that for a period of two (2) years from the date of purchase or (100) one hundred wash cycles, whichever occurs first, desco statshield ? esd smocks will be free of defects in material (parts) and workmanship (labor). within the warranty period, a credit for purchase of replacement desco statshield ? esd smocks, or, at our option, the statshield ? esd smock will be repaired or replaced free of charge. if product credit is issued, the amount will be calculated by multiplying the unused portion of the expected two year or 100 wash cycle life times the original unit purchase price. call customer service at 909-627-8178 for a return material authorization (rma) and proper shipping instructions. you should include a copy of your original packing slip, invoice, or other proof of purchase date. any unit under warranty should be shipped prepaid to the desco factory. warranty repairs will take approximately two weeks. if your unit is out of warranty, call customer service at 909-627-8178 (chino, ca) or 781-821-8370 (canton, ma) for a return material authorization (rma) and proper shipping instructions and address. desco will quote repair charges necessary to bring your unit up to factory standards. warranty exclusions the foregoing express warranty is made in lieu of all other product warranties, expressed and implied, including merchantability and fitness for a particular purpose which are specifically disclaimed. the express warranty will not apply to defects or damage due to accidents, neglect, misuse, alterations, operator error, or failure to properly maintain, clean or repair products. limit of liability in no event will desco or any seller be responsible or liable for any injury, loss or damage, direct or consequential, arising out of the use of or the inability to use the product. before using, users shall determine the suitability of the product for their intended use, and users assume all risk and liability whatsoever in connection therewith. maintenance statshield ? smocks must be laundered periodically for proper operation. desco recommends woolite. liquid detergents are better than dry because there is less caking and frictional wear. use only non-ionic softeners and detergents when laundering. launder statshield ? smocks in cool or warm water, tumble dry with low heat or hang dry. do not use bleach or fabric softener. launder statshield ? smocks by hand or with a washing machine. use a standard household machine on gentle cycle or use an industrial machine if pony (typically under 200 pound loads) machines are used. it is not recommended to launder these statshield ? smocks in heavy industrial laundry machines because it will lead to premature wear; degrading the esd properties. statshield ? smocks should be tumbled dry using low heat. the carbon-suffused mono-filament nylon is sensitive to heat and should not be exposed to laundering heat in excess of 120f. under normal wearing and recommended washing conditions, desco statshield ? esd protective smocks will maintain their usefulness and effectiveness for a minimum of 100 washings. some other esd smocks have as little as 1% suffused carbon and lose their esd protective qualities after a few washings. specifications fabric weight* 2.2 oz per square yard fabric content texturized polyester and a minimum of 9% carbon mono-filament nylon. carbon mono-filament conductive at 1 x 10 4 ohms, nonflaking and non-sloughing. surface resistance 1 x 10 5 < 1 x 10 7 ohms, per ansi/esd stm2.1 and esd tr53 of fabrics glass transition temp 250f flash point 1040f *fabric lots vary slightly in color and weight.
|
